It is possible to You can change the monitoring settings for each node and configure monitoring templates.
In the tab for each node settingSettings on Nodes tab, you can toggle the monitoring on or off status for each node. If By turning the toggle for monitoring ON/OFF toggle is set to OFF and savedsaving the settings, all monitoring for the corresponding that particular node will be stopped.
...
The In the Templates tab allows , you to can modify and apply monitoring templates to the nodes.
There are four types of monitoring templates available:
Alive monitoring
Backhaul Monitoring
AP Statistics
AP Scan
...
The modified changes made to a template will be effective for all the nodes to which it is applied.
It In addition to existing templates, it is also possible to create a new template in addition to an existing one.
...
new templates from scratch.
...
The default monitoring template templates cannot be deleted, but a newly registered monitoring template the monitoring templates created newly on this screen can be deleted removed by clicking on the "Delete" iconRemove" icon.
Using MQTT Moniroting
| 情報 |
|---|
On PCWL-0400/PCWL-0500 series which employs firmware with MQTT functionality, you can use MQTT monitoring mode instead of PING monitoring mode by choosing “Active mode“ for each node on Monitoring Settings → Settings on Nodes → Monitoring mode setting tab.
|
...
| 注意 |
|---|
On PCWL-0400 series, monitoring results by “Active mode” may not be shown on PicoManager® when PING error has been occurred just after (within about 5 minutes) switching from “Passive mode“ to “Active mode“. Under such circumstances, monitoring results by “Active mode” will be shown by rebooting the node. |